Are there specific G and M codes for a Fanuc control Hitachi Wire?

[J S Machine]

I have an old Hitachi (1988) wire EDM that was just installed in the shop and I'm trying to get it going. It has a SP150 control on it, and I am trying to figure out some differnt codes. I know som of the basic stuff, but I was wondering if there were any M codes specific to EDM, like one for wire run, flushing on, edm power on, etc. There are buttons for these, but I was just trying to find some M codes so I can signal them from the program instead of manually turning them on. I tried M8 for flushing, but that doesn't work.

Here is the control




Thanks

[Chopit]

We've got a very similar machine in our shop, ill check it out for you tomorrow. :-)

[Chopit]

Alrite, so i checked the manual and here's what i found:

M21 PWB Function ON
M22 PWB Function OFF

M40 Discharge OFF

M41 Cutting power ON
M42 Wire feed ON
M43 Dielectric fluid supply ON
M44 Wire tension ON

M80 Discharge ON

M81 Cutting power OFF
M82 Wire feed OFF
M83 Dielectric fluid supply OFF
M84 Wire tension OFF


As i wrote in my first reply, It's a very similar machine but not identical so it might not match, But i got my fingers crossed :-)

[mitronas]

Dear colleague
I found your link CNC Zone. We have in the same machine as you
Looking for full documents for machine HITACHI SEIKI H-CUT 203M sp 150 FANUC / 1988
We would be grateful if we could buy a copy or get the link where we could purchase.

Thank you in advance
Vilius