Cincinatti cnc problems need help

[Dan D]

I have a 1984 Cincinatti VMC with a arcamatic control. The machine was with out power for some time and it lost its parameters.The machine will not do a thing. How do I get it to run again. Any help would be great. Dan

[marx911]

I have a 1984 Cincinatti VMC with a arcamatic control. The machine was with out power for some time and it lost its parameters.The machine will not do a thing. How do I get it to run again. Any help would be great. Dan

do you have the system tapes? and you should have marrage parameters in a folder that matches that machine... you will need these at the very least I would think also what model control?

Mark

[mshopsteve]

i have the same machine, it was dropped in a move,execitive tapes i have two vrs. could this help? i know it has been longtime from your post.

[mshopsteve]

i may have extra tapes to help?