FANUC OT - MIYANO

[dwilcox@km-prec]

We have a Miyano BNC-34T with a Fanuc OT control. Last week I lost my RS232 settings used to send and receive programs to the machine. I looked in the manual and found the baud rate, stop bit, and parity settings. I cannot find the setting for the flow control. Does anybody have this information that I could use and check against what I have set is correct? I have the cable from the machine connected to the COM 1 port.

Thank you.

[parveenk78]

Dear sir

i have a miyano ANC-45S i need the 900 series parameter for this machine we lost the memory , can you send me the parameter 900 series from your machine at my email id
kaptronindia@gmail.com our control is fanuc OTT( double turret and head machine we have)