Help with tool nose radius comp

[mcash3000]

I am running a Murata MW200 with fanuc 18i control. I cannot figure out how to use the tool nose radius comp on this machine. I thought you were supposed to input the radius in the offset screen, but there is nowhere to input the radius. I was wondering if there is a parameter you have to turn on.

Does anyone have any examples of using the tool nose radius comp with fanuc controls?

[dcoupar]

If you press OFFSET/SETTING you don't see this display?

[mcash3000]

I only see the x and z offset selection. Maybe there is a parameter to turn on the radius comp.

[mcash3000]

Does anybody have any suggestions for tool nose comp parameters

[dcoupar]

I would call your dealer and tell him you want to BUY the option.

[mcash3000]

the parameter to turn on TNR is 9927.6

[dcoupar]

mcash3000: The owner of this site has requested (demanded?) that Fanuc option parameters NOT be posted here. Please read the Sticky announcement in the Fanuc forum.