LinkBack URL
About LinkBacks
You might need a newer version of mach3. And to install the plugin, just place the file on your desktop and double click it there.
| | |
I tried to install the plugin file for Griffin PowerMate. I transfered it to the Mach3 directory and double clicket but I got a message that told me that Windows can`t open this file if it doesnīt know which program which created it.
What do I need to do?
You might need a newer version of mach3. And to install the plugin, just place the file on your desktop and double click it there.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I have Version R1.84.000
I don't think R 1.84 supported plugins.
Gerry
Mach3 2010 Screenset
http://home.comcast.net/~cncwoodworker/2010.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I have now updated to latest version and the plugin opened but I can´t get the powermate to control or change between the axis.
Do I need to configure any setups in Mach3?
Hi,
Sorry to resurrect this fading thread, but:
My powermate's 'click' switches between the 3 axis (Good thing, it seems to work a bit) but I can't get it to jog... (arrow keys do, but not the thing..)
Where could I get some more info?
Regards, Paul
anyone figure this out? i have the same issue here.
Posting Permissions
| | |
