Hey guys [and gals] I'm looking for some feed back on the Hypertherm Edge II control system. We're looking at some new equipment here at the day job and it comes w/ this controler. Anyone had any experiance[s] that they would like to share? I've heard some negative stuff about it.. but then I also have some experiance w/ Hypertherm in general and have always liked there products to date.
Just trying to 'look B 4 I leap' so to speak..
[btw, yes.. I could build my them a machine.. but I'm not sure I want that much resposiblity. Building mine was a big enough headache ]
The more I know... the more I realize I don't
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)