Does anyone know how to change the feed plain on a Fagor 8055M? I run a 4 axis machining centre and I do 90 % of my programming using the canned cycles as most of the work is 2 1/2 D. If I set my Z feed to start from 0 the machine rapids down to +1mm then starts at the feed rate programmed or if I set the Z to start at 10mm the machine rapids down to 11mm then starts the programmed feed rate. The machine does this with all the canned cycle programs, the reason I would like to change this is because alot of the components that I have to machine are fabricated from folded and welded black plate and 1mm is sometimes too small on components that are over 2 metres long, resulting in some carbide cutters getting smashed. I assume because all the canned cycle programs use 1mm it could be one setting in the parameters that can be changed for all. 3mm would be nice!