Hello, I am new here
i just purchased a lathe, Wabeco D6000E, and I am going to have to run the Mach3 controler softwear from my laptop. Is this going to be difficult, a problem? I have no manual for the Mach3 softwear, anybody now where i can aquire one? Last question, can anybod running this tell me if I can use it as a digital read out in manual work?
Thanks, and sorry for the stupid questions, up front!
You can download a manual at www.machsupport.com
Some laptops will not run Mach3, but the only way to know for sure is to try and see.
Mach3 2010 Screenset
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)