I have found myself in a bad situation. My only setup\operator up and quit on me. I have a shop full of Mazak mills and lathes and 2 Cincinnati's. I know G code and Mazatrol so no problems there. I just don't know the controls. I can go from job to job and edit\create probgrams. I don't know how to set a tool using the tool probe. I am not worried about X and Y just yet. I am focusing on getting my Z's set. I have the operator's manual but the programming manual has some how grown legs and walked off. Any help would be great. Cincinnati is my next call but I thought this site would be more helpful.