To clarify this better.
Picture a race car frame, better yet a dragster frame, with 4 long runs, with all the braces perfectly joining these 4 long runs.
I can't just take the tube out, and turn end for end, for the 0,0 start point has to be retained for perfect fit up. These clusters get more complicated as you add more tubes.
I was planning on a 1/8" end mill at 3" min. travel speed, well actually the mill doesn't move,(except to plunge cut into the tube) but the tube rotates slowing to and from the end mill, thus creating the profile.
The entire profile of each tube is easly enough drawn out on solid works.