Cnckeycut Turbocnc problem

[arbus]

I am using cnckeycut. www.cnckeycut.com with a sherline milling machine and have been trying to set it up using turbocnc. cnckeycut runs fine with mach2 but with turbocnc i get the offsets all screwed up. Is gcode the same for mach3 and TC? Is there different M codes?
I want to set it up on an older laptop that wont run mach properly.

[Bubba]

arbus,
Yes, there are differences in some of the g-codes!
As I don't use Mach, I don't remember them off the top of my head but when I was trying to figure out which controller I was going to use; I seem to remember some differences. Also, there are some differences in the codes between V3.x and V4.x of Turbocnc.

You need to sit down with a listing of the codes from the manuals sitting side by side to see the differences.

[blackbird_leys_]

Hello everyone! I'm trying to get hold of CNCKeyCut, but having read the through forums and found the link www.cnckeycut.com, it appears that their website is unavailable. I've trawled through the Internet, to try and find someone selling it, but to no avail? Is there anybody here, who could supply me with it?

[arbus]

Hi Blackbird,

Yep, the website is not operational at the moment. I have been in contact with previous owner and i am going to take over the site soon. There are some big changes we have been working on. Mostly now will be using mach3 screens (wizzards) and new designs for cnc key machines. i am going to make the Mach3 screens available soon for download. Website is still a few weeks off.

[blackbird_leys_]

Hi Blackbird,

Yep, the website is not operational at the moment. I have been in contact with previous owner and i am going to take over the site soon. There are some big changes we have been working on. Mostly now will be using mach3 screens (wizzards) and new designs for cnc key machines. i am going to make the Mach3 screens available soon for download. Website is still a few weeks off.

Phew! Thanks for that! I look forward to seeing the site and the changes. :-)