LinkBack URL
About LinkBacksIs it possable to save your Work and Tool off-sets to a floppy so that they can be loaded back into the control at a later time ?
I see with this how to load them, is there a way to save them ?
Using a FANUC 16i-M control.
_
Saving Work and Tool off-sets to floppy for later loading ? Is it possable to save your Work and Tool off-sets to a floppy so that they can be loaded back into the control at a later time ?
I see with this how to load them, is there a way to save them ?
Using a FANUC 16i-M control.
_
~ What was once an Opinion, became a Fact, to be later proven Wrong ~
Most of the fanuc "i" controls will have a [oprt] soft key on the offset page. You may have to press the right arrow soft key to find it. Once you press [oprt], press the right arrow soft key again until you see [punch]. press that, then execute.
Soft keys vary from control to control based on version and screen size.
Humm... just like saving a full program then ?
Glad it was not a snake
Thanks.
~ What was once an Opinion, became a Fact, to be later proven Wrong ~
Posting Permissions
