Results 1 to 1 of 1

Thread: Verticle Borer Retro-fits

  1. 04-12-2006, 04:22 AM #1
    Burgs
    Burgs is offline
    Registered
    Join Date
    Jun 2005
    Location
    Australia
    Posts
    23
    Downloads
    0
    Uploads
    0

    Verticle Borer Retro-fits

    Hi
    Looking for advice on converting a Webster & Bennet verticle borer to CNC.
    It has a 36" chuck.
    We will need to be able to thread as well.
    Mechanically it does look all that hard for the 2 axis, but the drive will be a bit different. It maybe possible to retain the gearbox for the spindle drive I guess.
    Best Regards
    Burgs
    Last edited by Burgs; 04-28-2006 at 02:28 AM.

« Macro for a probe signal | BROTHER HS-70A Post »

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.