Alarm EX2322 on Warner Swasey 0TA

[suryamasinka]

Hi, all
My Lathe Machine, Warner Swasey with Fanuc 0TA was alarm EX 2322 during Power ON, But I can move both X and Z axis, also zerro refference. Where can I get the manual or alarm list of this machine. Thank you for helping

[gridley51]

Which W&S do you have?

[suryamasinka]

Thank you for respons,
My Machine was Warner Swasey : WSC6 (fanuc 0T6), It was turning CNC machine, I got it directly from Japan and all of the font in the monitor was in Japanesse, so It's difficult to understand..

[gridley51]

You are very fortunate,the alarm is not serious.
EX 2322 is REQ Chuck motion.This is asking you to open and close the chuck so the control can verify the proximity switches on the end of the spindle.
It`s just part of the start up procedure.

Start up on these machines is:-

Jog axis away from reference points.
Ref X
Ref Z
Ref turret by pressing turret forward and reverse buttons simultaneously.
If tailstock is fitted:-
Swing tailstock in and extend quill.
Retract quill and swing tailstock back.
Open and close chuck.
Start earning money.

Have you got an email address?
Ask Murata if they can do a Service Manual for the WSC6.The one I have is for an OTB control but it will be ok for you.The only number I can find on it is 8801-38-100.
MAG Group should be able to supply one too,but be careful as they are well known for supplying the wrong thing.

Mark.

[suryamasinka]

Thank you Mark,

Your advice is very useful for me...
Now, I understand why the machine couldn't run..
But, the machine still have a problem during tool changer cycle. While running a program after toolchanger cycle the spindle was stop and the program was hold. It need to push start cycle again to continue the program,
What's wrong with the machine..?

[gridley51]

Can you post a bit of your programme?

Mark.