Willing to pay good money for meaningful advise, help, consultation, etc. ...
I need to make a servo drive Mitsubishi MDS C1-V2 to spin a motor to test if that servo works.
My current setup is:
CNC MELDAS C64+sensor screen
Servo drive Mitsubishi MDS C1-V2
Motor HC353BS, or a few other alternatives available.
Power supply MDS CV-260
All this is NOT connected to machine.
If some other components are necessary to make what I need happen I will get them.
Contact: email@example.com, (502) 493-1352, or here in the thread or private messages.