Hi all, I've just loaded a program into an old Bridgeport Interact 412 running Heidenhain TNC 151, that I created using Mastercam.
I've come across an error while trying to do a 26x6mm slot, using a 6mm cutter (set to 5.98mm diameter). When it gets to line 54 I'm met with the error "Angle Reference Missing".
40 TOOL CALL 3 Z S3500
42 L X+80.950 Y-0.010 R0 F9999 M03
43 L Z+10.000 R0 F9999 M8
44 L Z+2.000 R0 F9999
45 L Z+0.000 R0 F100
46 L X+90.000 Z-0.474 R0 F200
47 L X+90.007 Y-0.007 R0 F200
48 L X+90.010 Y+0.000 Z-0.475 R0 F200
49 L X+90.007 Y+0.007 R0 F200
50 L X+90.000 Y+0.010 Z-0.476 R0 F200
51 L X+80.000 Z-1.000 R0 F200
52 L X+70.000 R0 F200
53 CC IX+0.000 IY-0.010
54 C X+69.990 Y+0.000 DR+ R0 F200
55 CC IX+0.010 IY+0.000
56 C X+70.000 Y-0.010 DR+ R0 F200
57 L X+90.000 R0 F200
58 CC IX+0.000 IY+0.010
59 C X+90.010 Y+0.000 DR+ R0 F200
60 CC IX-0.010 IY+0.000
61 C X+90.000 Y+0.010 DR+ R0 F200
62 L X+80.000 R0 F200
63 L Z+10.000 R0 F9999
I'm not too familiar with Heidenhain programming to be able to see what's wrong, any programs are made using Mastercam and I'm used to Fanuc .
Can anyone shed any light on this for me please? Is it because the cutter rad is so close to the slot rad?