Hi, just picked up an old ABC Systems 2d router at auction and I'm trying to find the best way to run this. It had an old Win95 pc originally which was grabbed by someone else at auction so I'm stuck figuring out the best way to run this. So far I've talked to an ABC systems rep who said they can sell me Enroute basic + post for $2500. it also comes with Winspool which only runs on Win98. So I can create my design in Flexisign, send it to Enroute which in turn feeds it to the drive unit using Winspool.
So, any ideas on a cheaper way to do the Enroute + post and Winspool? btw, Enroute doesn't run on Win98 and Winspool needs Win98 or older. So that means two computers at this point. Also the Enroute post is for the Burny Servo Pack drive unit (controller) so I would need that too.