Keling with EMC2

[AKMike]

I'm trying to set up my first cnc project with EMC2 but the motor doesn't turn. It just sends out a high pitch.

The motor model is "Type 57BYGH408", CW NO: 10.01.21. It's a 290 oz 4 wire stepper.
Controller Board: Keling, DB25
Power: Keling: KL-350-36
Drivers: Keling 4030

I do have 36 V coming out of the power supply and a 5 volt supply going into the controller.

I don't have any inputs (stops or limit switches) right now and I'm just trying one motor on the X axis.

I'm sending screenshots of the EMC2 set-up pages.

If you have any input, I'd greatly appreciate it. I've been at this for four days.

Mike

[Kelinginc]

pls check this

emc + keling compatibility?

http://www.kelinginc.net/CNCNEMA23Package.html

[GaryCorlew]

Turn your max accel down to about 1 and try it there