new to asking questions here but over quite a while I have been reading all the posts to glean advice on retrofitting a miller with cnc and have now a few question,s to ask, I have chance of buying a set of four unused Swiss 6600-30 Sobonze motors, please see: http://www.sonceboz.com/medias/produ...600-30-v08.pdf
And a set of four Compumotor CX indexer controllers please see: http://www.parkermotion.com/manuals/C-CX/C-CX.htm#CX
What I would like to find out is are these motors and controllers compatable to use together?
The miller I have is called a "Solid" i believe Swiss or German make, table size is 24" x 6" on normal dovetail slides and square thread screws.
I work as a designer in stone using AutoCad and Inventor 3d and have a download demo of Vetric cut3d and Mach3 so this side is no problem to me, just the power side to sort out.
Looking forward to hear from you guys you give a lot of helpful advise out to a lot of people keep up the good work.
from the UK