edit key offset parameter - CNCzone.com-The Largest Machinist Community on the net!

mcash3000 · #1 03-10-2009, 05:57 PM

everytime i make an offset, whether it is a geometry or ware, i have to use the edit key.
does anyone know whcih parameter controls the edit key to make offsets on the fanuc mxp-200i control?

msa · #2 06-28-2009, 05:49 AM

Originally Posted by mcash3000

everytime i make an offset, whether it is a geometry or ware, i have to use the edit key.
does anyone know whcih parameter controls the edit key to make offsets on the fanuc mxp-200i control?

I'ts in PMC maid bi a Keeprelay or or the ladder neads to bi modiid.

dcoupar · #3 06-28-2009, 10:54 AM

What are parameter #3290 bit 7 and #3291 bit 0 set to?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Radius Offset and Length Offset	jim_stoll	Dolphin CADCAM	13	10-14-2010 08:47 PM
FANUC 3M G54 OFFSET, H-OFFSET----Please help!!!	cjchands	Fanuc	2	05-25-2009 12:22 PM
Need Help!- Fanuc O-T Wear Offset Parameter	gollame	General CNC (Mill and Lathe) Control Software (NC)	4	03-10-2008 07:40 PM
edit for ptooltable	fx5	Post Processor Files	4	03-17-2005 01:09 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)