| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-02-2008, 09:13 PM
| |||
| |||
Model: Avenger 200C (no tailstock) Control type: Acramatic 850SX Machine Serial Number: 3650 A0C95-0003 Here's my problem: The part that I'm trying to load into the spindle has a spline and there's a splined collet inside the workholding (chuck). I want to start the spindle rotating (at 30 rpm) with the chuck both open - to orientate the splines, and closed. This lathe currently will not allow me to program it this way without receiving an alarm. I can do one or the other but not both in the same program. I don't want to defeat the chuck open/close foot pedal safety switch. The foot pedal should not open the chuck with the operator door closed. That is the way it is now. Can anyone help code around this problem, Thanks, John.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Acramatic 2100 | clayman | General Metalwork Discussion | 1 | 02-18-2011 05:29 PM |
| Acramatic 950 | pieface | General CNC (Mill and Lathe) Control Software (NC) | 5 | 07-10-2010 09:45 AM |
| DNC for Acramatic 900 | winchdoc | Machine Problems, Solutions , Wireless DNC, serial port | 21 | 02-14-2009 07:37 AM |
| acramatic 850T | mariusborza | General Electronics Discussion | 1 | 12-07-2006 09:46 AM |
| acramatic 900 | PICMAN | General CNC (Mill and Lathe) Control Software (NC) | 0 | 11-27-2006 11:20 AM |
| | |
Linear Mode
