| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-01-2008, 08:54 AM
| |||
| |||
Looking for a Bandit Control. Rigger dropped mine off truck! I'm retired machinist and grew up with this control. Too old to change. Too much damage to consider repair. Thanks, Robert..........toppik@aol.com  |
|
#2
09-01-2008, 02:50 PM
| ||||
| ||||
| To old to change? In the case of a Bandit, that's like being in too much pain to take a pain reliever   You may not have heard of 'The Shadow', but that is a relatively modern version of the old Bandit. Its not 100% interchangeable with Bandit code, but close. I think rad comp doesn't work as well with the Shadow as the Bandit, not sure if you used that a lot. They also incorporated standard work shifts in the Shadow, so that means that the G58 save position command is no longer available. The Shadow is available from Control solutions in Bozeman. One thing it has is 10000 line memory compared to the Bandit's 1000 'word' memory. The reason I'm suggesting this, is that perhaps an old restored and working Bandit might be quite expensive to come by.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bandit Control | DieGuy | General CNC (Mill and Lathe) Control Software (NC) | 1 | 02-05-2011 08:17 PM |
| Shizouka w/Bandit 4 control / to buy or not?? | teamjnz | Knee Vertical Mills | 4 | 09-29-2008 03:01 AM |
| Hardging HC with Bandit control | Kevin Taylor | General CNC (Mill and Lathe) Control Software (NC) | 4 | 05-09-2008 11:24 PM |
| Mastercam to Bandit control | jjclear | General CNC (Mill and Lathe) Control Software (NC) | 2 | 12-21-2007 10:21 AM |
| Bandit Control ? | jdelaney44 | Bridgeport and Hardinge Mills | 3 | 03-06-2005 08:36 PM |
| | |
Linear Mode
