MachMotion Questions

[packratus]

Hello everyone,
This is my first post and hope it is in the right area.
I have a Ex-Cell-O mill with an Anilam Crusader M controll that is starting to give me some trouble. Working with Jerry at Anilam narrowed it down to some component getting hot on the black or orange boards. Going to try to get more air inside the box but I think i'm just delaying the enviable, replacing the controller.
Looking at a Mach Motion controller and was wondering if any of you have experience with their equipement and company? How is their support and tech
help? Talking with their tech he feels that the new board they have will allow me to keep the scales and the existing servos, drives.
Looking at the forums the Mach3 software they use will be fine for my needs
as i am mostly trying to eliminate digging out the rotary table.
I know that i cound get the software, buy the components and put a system
together for less than the Mach Motion control but when you figure the time it would take(that i don't have) the cost looks good.
Any feedback or other suggestions are appreciated.


Thanks