| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-03-2008, 05:12 PM
| |||
| |||
| Adapting to G codes Hello, I am new here, Great forum you guys have! Currently, I work for Mahr. I run a Fryer Mill with Anilam controls. I just had an interview with a prospective employer today who wants experience with G coding. I haven't had the need to use G-codes since I was in school about 3 years ago. Considiring this, how hard do you say that it will be for me to adapt to this new mill that is run with G-codes. The person who interviewed me could not tell me if the machine is a Fanuc controlled machine or if it has any conversational programming on it. All he knew was "no one in the shop can run it and it uses G-codes. Can you do it?" I'm kind of baffled on what answer to give him. When I trained on the Anilam and the Mazatrol I had no problem with the learning curve. Just looking for some input. Thanks in advance.    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M-codes and G-codes 4 Matsuura ES-1000V | maximusek | G-Code Programing | 2 | 11-27-2007 07:41 AM |
| Adapting a power feed to the ST | dahui | Shopmaster/Shoptask | 3 | 01-09-2007 09:54 PM |
| Adapting Lasers for CNC | Marc Soren | Laser Engraving & Cutting Machines | 10 | 09-14-2005 10:27 AM |
| Adapting DRO for CNC use | CaptnVideo | General Electronics Discussion | 6 | 04-08-2005 12:57 PM |
| adapting a router to mini? | JFettig | Benchtop Machines | 0 | 04-30-2004 07:51 PM |
| | |
Linear Mode
