need help with toolsetting macro - CNCzone.com-The Largest Machinist Community on the net!

parksteel · #1 05-29-2008, 11:30 PM

Hey guys,

I have an issue, minor, but a headache all at the same time. Had an editing issue in program with a macro for toolsetting. Working on a Cincinnati/Lamb hawk 250, Fanuc 21i controller. Our G code prior to position settings was overwritten and we dont remember what it was

. Now that was within the O8k macro, the working macro is an O9100+, which to us is unviewable. First off I know that I can access that program as a view only through parameters, but I dont know which one it is. Secondly I can get her up and running again by viewing that one, because I know that I can at least grab the right G code to rewrite in the O8k program. Any help here would be outstanding !!

dcoupar · #2 05-30-2008, 09:57 AM

3202 bit 4 (NE9) unlocks your 9000 programs

parksteel · #3 06-06-2008, 12:17 AM

Thank ya, I did use your info, just havent had the chance to pop back on to thank you for it

dcoupar · #4 06-06-2008, 10:15 AM

No problem. Good to know it was helpful.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
macro help	dasandy	Fanuc	5	03-17-2008 09:20 AM
Convert Fanuc Macro to Fadal Macro	bfoster59	Fadal	1	11-09-2007 12:41 AM
M6 macro	ben_heinman	General CNC (Mill and Lathe) Control Software (NC)	2	03-30-2007 01:37 PM
M6 Macro	ben_heinman	Fanuc	5	03-29-2007 05:02 PM
Macro B	jorgehrr	G-Code Programing	2	01-31-2007 03:23 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)