| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
05-02-2008, 10:03 PM
| |||
| |||
 Does anyone know if the run time is correct when you are checking a program on a PC with Anilam 4200t Offline software. The Feedrate is correct but it says the program runs in 55 seconds, It should run in 10 to 15 Minutes. Help Please. Large Threaded part feedrate is correct to spindle speed but time is WAY SHORT???????????    |
|
#2
07-15-2010, 06:59 AM
| |||
| |||
| Hi everyone, I have an Anilam 4200 it was running just fine I opened the panel box and looked to see where a cable was pluged in and when I started the machine back up it does not boot into the program screen it comes up with CRC error reading drive C does anyone know what this means and how to get passed it? |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anilam 4200t Offline software, anyone have it? | racingdave | General CNC (Mill and Lathe) Control Software (NC) | 2 | 05-03-2008 10:48 AM |
| Need Anilam 4200T post processor | javajesus | Post Processor Files | 0 | 12-06-2007 01:26 AM |
| Mach2 offline only | mayhugh1 | Mach Mill | 1 | 10-01-2006 12:59 AM |
| trakcnc2 offline HELP HELP HELP | shunter1625 | General CNC (Mill and Lathe) Control Software (NC) | 0 | 10-11-2005 01:28 PM |
| Trak CNC 2 Offline System | seb fontan | Mazak, Mitsubishi, Mazatrol | 0 | 02-25-2004 01:11 PM |
| | |
Have Question about Anilam 4200t Offline 
Linear Mode
