| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-30-2008, 03:40 PM
| |||
| |||
| 417 & 427 codes ok earlier today i was working with our programer to set up a fanuc series o-td. well as we were setting up we moved it to low out off the x axis and an alarm went off.. a code 101 went off... and i came on the site and read to shut dawn and power up by holding delete and reset on power up. well go figure all the parameters zeroed out.. well we just finishe3d putting in all the paramiters and were lost at this pint.... whats the next step to getting it running    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G68 and G69 codes | kot137 | G-Code Programing | 5 | 06-24-2010 12:51 AM |
| M-codes and G-codes 4 Matsuura ES-1000V | maximusek | G-Code Programing | 2 | 11-27-2007 07:41 AM |
| Not new to g-codes but looking for some help | stang-man | G-Code Programing | 6 | 10-01-2007 01:38 PM |
| g codes | AJFab | G-Code Programing | 1 | 05-19-2006 09:16 PM |
| G codes | Citron | CamSoft Products | 14 | 06-10-2004 11:59 PM |
| | |
Linear Mode
