Help with tool nose radius comp - CNCzone.com-The Largest Machinist Community on the net!

mcash3000 · #1 04-24-2008, 06:14 PM

I am running a Murata MW200 with fanuc 18i control. I cannot figure out how to use the tool nose radius comp on this machine. I thought you were supposed to input the radius in the offset screen, but there is nowhere to input the radius. I was wondering if there is a parameter you have to turn on.

Does anyone have any examples of using the tool nose radius comp with fanuc controls?

dcoupar · #2 04-24-2008, 11:23 PM

If you press OFFSET/SETTING you don't see this display?

mcash3000 · #3 04-25-2008, 09:12 AM

I only see the x and z offset selection. Maybe there is a parameter to turn on the radius comp.

mcash3000 · #4 04-29-2008, 10:08 PM

Does anybody have any suggestions for tool nose comp parameters

dcoupar · #5 04-29-2008, 10:34 PM

I would call your dealer and tell him you want to BUY the option.

mcash3000 · #6 05-08-2008, 10:02 AM

the parameter to turn on TNR is 9927.6

dcoupar · #7 05-09-2008, 09:25 AM

mcash3000: The owner of this site has requested (demanded?) that Fanuc option parameters NOT be posted here. Please read the Sticky announcement in the Fanuc forum.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
tool nose radius comp	joe1970	G-Code Programing	8	02-24-2010 10:43 PM
G42 Tool nose radius.	al-108	Okuma	5	03-02-2008 02:39 AM
Need Help!- Tool Nose Radius	speeeeed	Haas Lathes	5	02-25-2008 05:11 PM
G143 Nose Radius Comp. - Hitachi Seiki HT23J	jbird68	G-Code Programing	3	08-02-2007 12:41 PM
tool nose comp.?	pp-TG	General Metalwork Discussion	1	09-19-2006 04:36 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)