| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-11-2008, 05:32 AM
| |||
| |||
 controls west board (BTR) mc500v hi, I had a problem with my matsuura mc500v machine, I want to use a pc with it, but the BTR (controls west board) possiblly had been set wrongly. I'm not sure, i sent codes to the machine, the LEDS were blinking, but the machine read nothing. can anyone help to give any guide ? thank very much! tim    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Matsuura MC500V | wyobmf | Knee Vertical Mills | 22 | 05-12-2010 04:41 PM |
| West Central PA | AlexBanich | Employment Opportunity | 1 | 12-22-2008 05:06 AM |
| West Amp Servomotor help | johnd | Servo Motors and Drives | 9 | 12-11-2008 04:20 PM |
| West Virginia | millman52 | Mentors & Apprentice Locator | 0 | 10-04-2007 05:09 PM |
| Mastercam 9 Postprocessor for Matsuura MC500V mini-master | luis_gts | Post Processor Files | 5 | 06-04-2007 03:04 PM |
| | |
Linear Mode
