| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
03-04-2008, 07:39 PM
| |||
| |||
I've got a cnc knee mill with centroid m-400 control and was wondering who/what determines max IPM? I have a feeling my cnc's limits are set low, in fact it seems as though the servo motors aren't even getting a work out. My max cutting speed is 60 ipm and rapid is around 128. Would it hurt any to bump these numbers up a bit? As long as i stay within safe servo current draw limits and not get them too hot? Also, on a side note... Do any other centroid users use the threading cycle to cut holes instead of circular pocket cleanout? At least for holes that are less than twice the diameter of the end mill? Why doesn't centroid add this canned cycle? Seems like a simple mod to the threading cycle to cut quick holes.  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| More Speed | BMTECH | CNC Wire Foam Cutter Machines | 9 | 12-13-2006 10:18 PM |
| Speed and win xp | ALEXCOMO | FeatureCAM CAD/CAM | 3 | 10-13-2006 06:05 AM |
| BPSeriesI / Centroid control- Spindle speed all out of whack with speed dial? | peter.blais | Bridgeport and Hardinge Mills | 9 | 08-08-2006 03:29 AM |
| need speed | Rainman229 | Shopmaster/Shoptask | 21 | 07-16-2006 12:49 PM |
| min speed exceeds max speed for axis "x"? | ljoe1969 | TurboCNC | 4 | 01-19-2004 07:49 AM |
| | |
Linear Mode
