Need Help!- Dynapath 20 CRT Cabling

[elnerdo]

I've just purchased a Tree Journeyman 310 with a non functional Dynapath 20 control system. I've powered up the controller from a 115V wall outlet and its come to life but unfortunately the previous owner has removed the cable that connects the CRT board to the controller.

So....my deal is if someone from the forum can send me a drawing that shows which terminal on the board, connects to which pin on the mating connector, I'll make you a spare cable and send it to you at no charge. This offer will be good to the first person to send me the info. It might take me a week or so to source the connector and fabricate it, but thats my offer. Send me a PM if you're interested.

[elnerdo]

ok, maybe the spare cable offer wasn't such a great motivator. a starbucks card for $10.00, movie passes?

[HillBilly]

This should be a short jumper to the MTB panel.

CRT----MTB Panel
1------- +12 GND
7------- +12 CRT
8------- CRT COMP
10------ CRT GND

Darek

[elnerdo]

Thanks, that was a huge help. This weekend I'll wire the CRT up and be one step closer to machining my first chip. BTW, I sent you a PM.