| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-16-2008, 03:45 AM
| |||
| |||
Hi, I have a XJ-3030 desktop,with NC Studio control software,i have had a bit of trouble with it,but that problem was fixed a couple of weeks ago,and it has been running fine. Today i was doing a bit of engraving when the spindle stopped,a message on the LCD display says E.009,When i press the program reset button and restart the machine,it goes fine for a few mins and then the spindle clicks off again and the E.009 message comes again. I am engraving on MDF and only at 0.5mm so no strain on the spindle,i take it that E.009 is an error message.Any ideas? Thanks Mike  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How Do I Post A Message? | CNCadmin | CNCzone.com FAQ | 2 | 09-09-2009 11:25 PM |
| Haas TM2 message? | Zeekh | Haas Mills | 3 | 12-07-2007 05:51 PM |
| G83 error message | HBFixedGear | Fadal | 14 | 01-30-2007 09:42 AM |
| HOw can I tell if PC-2 is getting message from PC | scheek | Mach Software (ArtSoft software) | 1 | 04-13-2006 09:36 PM |
| Why can't I put **********.com in message? | samualt | Forum Questions or Problems | 12 | 09-12-2004 09:52 AM |
| | |
Linear Mode
