| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-15-2007, 05:58 PM
| |||
| |||
| Mach3 controler softwear Hello, I am new here  i just purchased a lathe, Wabeco D6000E, and I am going to have to run the Mach3 controler softwear from my laptop. Is this going to be difficult, a problem? I have no manual for the Mach3 softwear, anybody now where i can aquire one? Last question, can anybod running this tell me if I can use it as a digital read out in manual work? Thanks, and sorry for the stupid questions, up front! Jim Burke    |
|
#2
10-15-2007, 06:08 PM
| ||||
| ||||
| You can download a manual at www.machsupport.com Some laptops will not run Mach3, but the only way to know for sure is to try and see.
__________________ Gerry Mach3 2010 Screenset http://home.comcast.net/~cncwoodworker/2010.html (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Yam With a O-T controler | 9566317 | Fanuc | 3 | 05-24-2007 10:01 PM |
| BP Series 1 - what can I rip out after a BOB Controler/Mach3 upgrade? | bbuonomo | Bridgeport and Hardinge Mills | 2 | 10-27-2006 03:26 PM |
| Do Xylotex board work with any softwear | hotroad | Xylotex | 2 | 02-19-2006 08:34 AM |
| cnc controler | gearcut | General CNC (Mill and Lathe) Control Software (NC) | 1 | 05-15-2005 10:46 AM |
| | |
Linear Mode
