| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-12-2007, 10:33 PM
| |||
| |||
Any body help me with Mitsubishi 60S When I executed a program from memory, sometime the machine stop(about 1 minute) the xyz axis not run but spindle still run so I must press Cycle start button to continue program. It issue T01 CAN'T CYCLE START 104( Relate to Feed hold Switch) T03 BLOCK STOP 0301(Single block switch)    |
|
#2
09-12-2007, 11:13 PM
| ||||
| ||||
| I used to encounter a similar problem on my lathe, although it is running a Meldas50 cnc. My problem turned out to be a bad connection to the spindle drive. It could not return a ready signal back to the controller when the spindle was at commanded speed.
__________________ First you get good, then you get fast. Then grouchiness sets in. (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help needed to connect Mitsubishi Meldas to PC | 2_jammer | Computers and Networking | 17 | 07-10-2010 05:22 PM |
| Mitsubishi Meldas 60S | BKCOM | General CNC (Mill and Lathe) Control Software (NC) | 0 | 08-29-2007 03:07 AM |
| Mitsubishi M-V60C w/c MELDAS 300M | Tulak | Mazak, Mitsubishi, Mazatrol | 2 | 06-14-2007 11:03 PM |
| ask for help about connecting pc to mitsubishi meldas 50s | samhai | Mazak, Mitsubishi, Mazatrol | 1 | 04-16-2007 04:39 PM |
| Mitsubishi Meldas 300-V | firestaromega | Computers and Networking | 3 | 05-24-2006 09:37 PM |
| | |
Linear Mode
