| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-04-2007, 06:20 PM
| ||||
| ||||
Being that I am still fairly new to the programming side of things and that I have never ran a yasnac based controller (I do see a lot of them for sale though) I was wondering what the differences were between the two controllers? Last edited by horst007; 09-16-2007 at 11:50 PM. Reason: poor grammar and spelling    |
|
#2
09-04-2007, 10:19 PM
| |||
| |||
| Our Mori MV40 has a Yasnac controller. The gcode is very similar (if not identical) to the Fanucs I've seen. I believe that Yasnac is a low cost alternative to the Fanuc monopoly. The operator interface is another story. Selecting programs, uploading and downloading programs, data entry. Completely different on a Yasnac. For example, the famliar INPUT / INPUT+ Fanuc style data entry becomes a global ABS/REL mode on the Yasnac. Bad things happen when you're in ABS mode and you think you've just added .001 to an offset. The Yasnac has a few other quirks, some minor annoyances. Takes some getting used to. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help on Yasnac 2000G | ktb100 | Machine Problems, Solutions , Wireless DNC, serial port | 8 | 07-05-2008 10:31 AM |
| need post for yasnac MX3 | ARIF AHMED | Post Processor Files | 4 | 08-02-2007 02:37 AM |
| Difference b/w Fanuc 0iA & 0iM | eng8248 | Fanuc | 1 | 01-30-2007 07:29 PM |
| Yasnac i80 error 102 | Boring Life | Fanuc | 14 | 04-08-2006 07:05 PM |
| Yasnac I80 | Gitanes | General CNC (Mill and Lathe) Control Software (NC) | 0 | 11-24-2005 12:00 AM |
| | |
What is the difference between Fanuc and Yasnac? 
Linear Mode
