| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
08-24-2007, 01:28 PM
| |||
| |||
I seen an Excello 604 CNC mill with Bendix controller up for auction and it's located not too far away. Just wondering if a machine with a Bendix controller is still worthwhile getting and using the way it is or is it a prime candidate for a retrofit? The machine is operational and is suppose to be in very good condition with not alot of time on it. We have been looking into getting a low cost CNC machine at work for short runs and intricate parts that are time consuming to make on a manual mill. We have a manual Excello knee mill and it's a fantastic mill. I prefer using it over our Bridgeport mill so I thought a CNC'd Excello would be ideal. Any thought? Carl     |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bridgeport series I mill using dynomotion controller | krz2_2000 | Bridgeport and Hardinge Mills | 21 | 04-06-2010 03:34 AM |
| Bendix dynapath 10AM, What have I gotten myself into? | karbunkle1952 | General CNC (Mill and Lathe) Control Software (NC) | 11 | 03-03-2008 08:55 PM |
| Bendix clutch | Chubs | Jet Engines and Ram Jets | 9 | 10-03-2007 12:02 AM |
| Question about Xylotex Controller and Sieg X3 mill | wwendorf | Benchtop Machines | 15 | 06-02-2007 07:51 AM |
| CNC-mill controller.. which? | TechGraphix | General CNC (Mill and Lathe) Control Software (NC) | 1 | 06-04-2006 08:05 PM |
| | |
Linear Mode
