crt screen on accurite millpower controls going out - CNCzone.com-The Largest Machinist Community on the net!

piketool · #1 08-09-2007, 06:39 PM

I have a problem with the the screen going dark about 10 minutes after booting up.Is there a board that can be replaced to fix this?Has anyone else experienced this.Thanks in advance.

outctrl · #2 08-09-2007, 06:48 PM

pike,
does it just blank off or act like you turned it off. there was firmware problems with some models about 2 years ago.

piketool · #3 08-10-2007, 05:45 AM

No I can still operate it but can;t see digital scales or soft key words.Thanks

markj · #4 07-02-2009, 02:48 PM

We have same problem about 10 min. after start up . We were told hit it hard on top of box this works almost all the time. ( was told by accu-rite repair to do this ) we are now trying to get new box they have tryed to fix it 2 time no luck

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Accu-rite MillPower	ddwiers	Bridgeport and Hardinge Mills	12	12-19-2011 08:24 PM
Homemade Screen Printer/Silk Screen	Sbthomas13	Machine Created Art	20	02-13-2009 06:35 PM
Jog Controls	dafowfidy	Mach Mill	2	03-21-2007 04:01 PM
Most Accurite CNC	ajl6549	General Metal Working Machines	2	03-06-2007 08:55 PM
Controls	Chuck Pool	General CNC (Mill and Lathe) Control Software (NC)	7	02-23-2006 11:49 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)