| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-19-2007, 03:31 AM
| |||
| |||
I have got few questions: 1. Is on the earth any free software that i could controll devices by parallel port? I do not mean NC code!! For example: Haveing connected one step or servo motor, sensor, mehanical relays over optobreakout board to PC and controll outputs and inputs from devices. Building programs maight be something similar like programming in Visual Basic 2. Does exist any low cost USB optobreakout board (not Gecko) to controll step/servo drives by (outputs and /or inputs)? Thanks Marko  |
|
#2
06-26-2007, 01:00 PM
| |||
| |||
| |
|
#3
06-28-2007, 06:32 PM
| |||
| |||
|
|
#4
06-28-2007, 06:53 PM
| |||
| |||
| http://www.linuxcnc.org/ Check out the excellent documentation about the HAL, hardware abstraction layer. It has ladder logic built in. I haven't tried it yet, but it looks like you could control just about anything with it. --97T-- |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| C++, Win XP, Parallel Port | Zumba | Coding | 7 | 03-29-2012 01:12 PM |
| parallel port cam software | mikie | DIY-CNC Router Table Machines | 4 | 11-24-2008 11:45 AM |
| Where's the parallel port? | cdlenterprises | Mastercam | 23 | 01-20-2007 05:23 PM |
| 2nd PCI Parallel Port | sunmix | Mach Software (ArtSoft software) | 8 | 11-22-2006 02:17 PM |
| Parallel Port | Shanghyd | Computers and Networking | 1 | 11-22-2004 11:56 AM |
| | |
Linear Mode
