| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
04-23-2007, 08:33 AM
| |||
| |||
I'm working with CMS's PK4816 CNC, it's being used to trim plastic parts for buses and such. There are two work areas, the table is split into 1-left side, 2-right side, and 3-alternating. The problem is that the parts we normally trim don't nearly take up half of the table...Is there any possible way to split each side in half again (to make 4 work areas)? So far the only way I've been able to put 4 parts on at once is to add one program to end of another program...very impractical and time consuming. This machine has a OSAI type s10/565 controller I'm not sure if it's possible without ordering completely new software for the CNC, however right now that may also be an option any ideas?  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extra capacity | cdlenterprises | Employment Opportunity | 1 | 02-26-2007 01:58 PM |
| extra lines in corel dxf | jeeplogic | General CAM Discussion | 0 | 12-21-2006 06:58 AM |
| Anyone have any extra QC30 tooling? | vmax549 | Bridgeport and Hardinge Mills | 2 | 03-10-2006 08:02 PM |
| R2E4 Extra Fan Upgrade? | arsenix | Bridgeport and Hardinge Mills | 1 | 07-11-2005 01:52 PM |
| Need help extra lines in dxf | carlnpa | Mach Software (ArtSoft software) | 3 | 03-19-2005 03:48 PM |
| | |
Linear Mode
