Error Axes Drive Fault on CHNC I - CNCzone.com-The Largest Machinist Community on the net!

asantos · #1 02-16-2007, 01:39 PM

Hi!

Do you Know what I need do with the CHNC I error Axes Drive Fault

Axes Not Enabled
Axes Drive Fault

error 6011

I Cheched the Tachometer and this is ok!

gridley51 · #2 02-17-2007, 03:00 PM

What drives does it have?
Mark.

asantos · #3 02-19-2007, 03:01 PM

I have a problem in this moment in X drive

I clean the four bruches of servo, this had too dirty
I don't know what more need do.

can you advise me?

the machine had z and x drive.

gridley51 · #4 02-19-2007, 03:13 PM

The drive will not enable because it has a fault and is not giving the cnc control the "drive healthy" signal.
When you look at the axis drives can you see what make they are and is there any red lights on them?
Mark.

asantos · #5 02-19-2007, 05:30 PM

yes, the red light is present, the machine turn on (singing) for 5 to 10 second and the red ligth turn on.

asantos · #6 03-12-2007, 12:33 PM

I fixed it, the problem was in the motor X, this had burned the brushes area.

I replace the motor and now is working perfectly.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dynapath Fault Error	buba447	Machine Problems, Solutions , Wireless DNC, serial port	26	02-15-2012 09:01 PM
Need drive for CHNC spindle motor	rkdygert	Servo Motors and Drives	0	01-27-2007 12:03 AM
Axis drive fault/off error message	Healey	Bridgeport and Hardinge Mills	0	11-08-2006 03:49 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)