| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-09-2007, 11:47 AM
| |||
| |||
just had a lns barfeeder installed on a okuma cadet.So many problems have happened since.My main question is why can i not run a program when cycle start is pushed....i can only run in single block.Even though the single block is off.    |
|
#2
02-25-2007, 07:36 PM
| ||||
| ||||
| Is the LINK mode switched ON or OFF? I think this may have something todo with the run mode. I take it you have been in contact with your local Okuma Rep regarding this problem also and had no luck?!? Regards Brian. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| need post okuma howa lathe | mike10 | Post Processors for MC | 2 | 07-02-2010 11:33 PM |
| G71 Threading for Okuma Lathe | pedgette | G-Code Programing | 6 | 11-30-2006 01:11 AM |
| SmartCam .tmp for Okuma LB15 with 5020L | xs-speed | Post Processor Files | 3 | 10-20-2006 04:41 PM |
| need help okuma howa lathe | mike10 | CNC Tooling | 1 | 09-16-2006 09:10 PM |
| Okuma Lathe question | dartplayer1 | Machine Problems, Solutions , Wireless DNC, serial port | 15 | 08-11-2006 03:12 AM |
| | |
okuma cadet lathe osp 5020l 
Linear Mode
