| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-03-2007, 05:04 AM
| |||
| |||
I did the internal self diagnostics that Anilam 1400m uses. I got an error code"FFFF" in the hard disk surface test. Does anyone know what it means. I would gues it means there is a bad sector on disk, but what does one do about it. There is nowhere in the manual that explains any of the diagnostic tools available. Thanks.    |
|
#2
02-16-2007, 09:04 PM
| |||
| |||
| If the control works i would not worry about it. I think the product was not quite "finished" so i would not trust the diagnostics too much.. it is obsolete now |
|
#3
07-31-2011, 02:14 PM
| |||
| |||
Hi, I need the software for a TW 105 RH mill. The table will not home X axis. Is there a diagnostic built into the program? The table goes the wrong way when homing and shuts the servo off. Please help!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anilam 3300MK | Buried | Machine Problems, Solutions , Wireless DNC, serial port | 13 | 04-13-2011 08:25 AM |
| ANILAM controllers | Beaker | General CNC (Mill and Lathe) Control Software (NC) | 8 | 04-21-2010 07:22 PM |
| Anilam Help | Turk88 | General CNC (Mill and Lathe) Control Software (NC) | 22 | 09-27-2007 03:28 PM |
| Anilam Power | scottmi | Phase Converters and VFD | 3 | 10-30-2006 08:23 PM |
| anilam 1100 | tmt_92021 | General Metalwork Discussion | 1 | 07-09-2006 12:28 PM |
| | |
Need software for the 1400m 
Linear Mode
