Lathe geometry offset - CNCzone.com-The Largest Machinist Community on the net!

01-23-2007, 02:53 PM

cncdigger

Join Date: Jan 2007

Location: Canada

Posts: 21

Lathe geometry offset

Have anyone heard of an X tool offset entered in the register as a radial value, or is it always diametral?

01-23-2007, 05:28 PM

HuFlungDung HuFlungDung is offline

Moderator

Join Date: Mar 2003

Location: Canada

Posts: 4,823

Sure, it could be either way, depending on the make of the controller.

__________________
First you get good, then you get fast. Then grouchiness sets in.

(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)

01-29-2007, 05:52 PM

cncdigger

Join Date: Jan 2007

Location: Canada

Posts: 21

Thank you for the info.

Alain

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FANUC 3M G54 OFFSET, H-OFFSET----Please help!!!	cjchands	Fanuc	2	05-25-2009 12:22 PM
Dimensions on 2D geometry	mayhugh1	SprutCAM	3	10-26-2006 12:02 AM
Geometry from NC	rherman	BobCad-Cam	2	09-21-2006 08:10 AM
rusty geometry	bdrmachine	General Metalwork Discussion	1	07-16-2006 04:34 PM
Anyone tried the 2D geometry tools?	S4 Monster	SprutCAM	0	02-02-2004 02:09 PM

All times are GMT -5. The time now is 03:03 AM.