| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
01-21-2007, 07:49 PM
| |||
| |||
| multable machine controls hi there hope this is in the right place. i have bean looking at bilding a mill and a plazma cutter i can't deside so i think that i will bild both. what i wont to know is can i use one pc to contual them both. could i run at the same time ? has any one done this be for. the pc will be at least a 15oomzh and the 512mb and a 80gb hd. what are good for a contoler pc?    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Machine Controls | SPEEDRE | General Electronics Discussion | 2 | 12-14-2006 01:10 PM |
| Controls | Chuck Pool | General CNC (Mill and Lathe) Control Software (NC) | 7 | 02-23-2006 12:49 PM |
| Replacing Floppy Drive on Machine Controls | ObrienDave | Machine Problems, Solutions , Wireless DNC, serial port | 2 | 07-31-2005 09:29 PM |
| Salem Controls Inc | Robbed6666 | Servo Motors and Drives | 0 | 07-06-2005 02:53 AM |
| | |
Linear Mode
