| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#13
02-15-2007, 01:10 PM
| ||||
| ||||
| Matt, Does that run on older Win versions? and do you know of anything for transmitting/recieving binary files, that does not require peliminary codes? Al.
__________________ CNC, Mechatronics Integration and Machine Design. “Logic will get you from A to B. Imagination will take you everywhere.” Albert E.  |
|
#14
02-15-2007, 02:18 PM
| ||||
| ||||
| Al, it should work except for the transparency function. If it doesn't, I can probably port it to older versions. I originally wrote it in Basic for use on a command line, I don't know if I still have that code, but it should work. I haven't tried it on binary files, it uses a standard read/write line by line algorithm.
__________________ Matt San Diego, Ca ___ o o o_ [l_,[_____], l---L - □lllllll□- ( )_) ( )_)--)_) (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
