Dahlih MCV 1020 Fanuc 10m

[burbankbrewer]

Dahlih MCV 1020 Fanuc 10m
Does anyone have a Dahlih MCV 1020 3 axis mill with a Fanuc 10m control? I need to get the pmc parameters for it. Fanuc had to change the master pcb board and now I only have the use of 15 tools instead of 20. I guess they didn't save everything or save it right. Fanuc said to get the parametrs from Dahlih, but this is proving to be a very slow process. If someone could send me the pmc file I would greatly appreciate it.

Thanks, jamie burbankbrewer@yahoo.com

[davestewart53]

I had a similar problem and I fixed it by going to the data table in the nc/pc selection and filling out all the tool numbers I am not sure if this is the same issue but is worth a look I also have a dahlih so I could down load the parameters for you

[burbankbrewer]

Thanks but it's fixed. There is a parameter to set for 20 tools, I have it somewhere but off hand I don't know what it was.