| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| General CNC (Mill and Lathe) Control Software (NC) General Discussion of CNC (Mill and Lathe) control software here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-14-2006, 09:38 PM
| |||
| |||
Anyone here upgraded their Milltronics control? I have a knee mill which had a crapped out mother board and I changed it for a board from an old pc. It is a little slow though and I would also like to increase program memory size which is currently only 100k. The current motherboard is an old 286 and the machine is a 93. Its not bad but it slows a bit on complex surfacing programs. Any insights would be much appreciated  Thanks!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
