My New/Old Anilam Crusader M has a problem - CNCzone.com-The Largest Machinist Community on the net!

L98FIERO · #1 08-29-2006, 07:30 PM

Hi everyone!

I bought an old (1986) mill equip with a Crusader M control that I was planning on retro fitting however the control does power up but the diagnostic tests show a 'DUART failed'. Is this fatal as in it's cheaper or easier to replace the control or is it an easy fix?

Any help would be appreciated!

LaVerne

Karl_T · #2 08-29-2006, 10:03 PM

Time for a new control. Even if you solve this one, it will just go down again. Today's hobby controls are light years better than the professional controls of 20 years ago.

Karl

JPW · #3 08-15-2008, 07:10 AM

Sorry gents. The uart was a brain fart on Anilam's part. It was to be for future use. The control doesn't have it installed.

Good luck - I still use my M.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)