07-04-2006, 05:49 PM
|
| | | Join Date: Jul 2006 Location: Canada
Posts: 21
| |
hay all, I am learning to run our new 5 axis Zephyr VTR machine with the heidenhain controller. The book that was included is not very friendly for understanding.
I am trying to do a datum shift for a X0,Y0 coordinate to shift to a X3.123 Y-1.234 coordinate. I try and used the Coordinate transfer button then try and bore a hole, but the shift doesn't take place...
example...
0 begin program inch
1 tool call 50 Z S1000
2 cycle def 7.0
3 cycle def 7.1 x3.123
4 cycle def 7.2 y-1.234
5 cycle call 208 (boring)
6 call cycle m3
7 m30
8 end program
could anyone help me out? dO I NEED A LABEL CALLL OR SOMETHING?? |
Linear Mode
