06-03-2006, 07:54 PM
|
| | | Join Date: May 2006 Location: Australia
Posts: 11
| |
Hello everyone, I'm trying to get an initial setup running, and have unfortunately had to reformat and load windows xp , I'm using KCAM version 4.11, within the CNC Controls box, initially I could jog the stepper motor in forward and reverse, and the big green writing for each axis would change as it "stepped". However with the new load of windows, I must have missed some setup procedure as I can nolonger jog the motor and see the corresponding big green writing for each axis change.
Any advice would be greatly acppreciated... |
Linear Mode
